How to use the Hex Roller

STANDARD DUAL METHOD

Step 1

Load the first wrap

Hold the roller with your dominant hand and the gripper with your non-dominant hand. Take the opposite end of the hand wrap and insert the actual wrap material—not the Velcro or loop—into the black slot/feeder. Pull it in the direction of the arrow, aligning the peg with the arrow and slot.

Get your wrap securely in place and ready to roll.

Step 2

Load both wraps

Make sure to place the actual wrap material onto the peg/axle. A small amount sticking out is normal. Make sure the wrap is secure and not loose, then load the second wrap the same way. Do not load the Velcro or thumb loop onto the peg.

Have both wraps loaded and ready to go.

Step 3

Get into position

Hold the gripper with your non-dominant hand and position the roller horizontally and parallel to the ground. Make sure both wraps are facing downward and are hanging straight.

Set yourself up for a smooth, tangle-free roll.

Step 4

Start rolling

With your dominant hand, turn the roller clockwise. Keep both wraps perpendicular to the roller and vertical to the ground, so they feed straight and evenly into the feeder/axle.

Turn the roller and let it do the work.

Step 5

Finish the roll

Keep turning until the wraps have rolled onto themselves. Near the end, the wraps may stick together slightly—simply separate them and continue rolling. Once fully rolled, pull the finished wraps out of the roller and you're ready to go!

Finish with neatly rolled wraps, ready for your next session.

Hot Tip!👇

If the wraps become twisted or tangled, move your non-dominant hand up and down while holding the roller. This creates a gentle wave through the wraps, helping straighten them out. Once they are straight, continue rolling while keeping them vertical and feeding evenly.

Fix tangles as you roll